Naslov: | A comparison between conventional triaxial and plane-strain compression on a particulate system using 3D DEM |
---|
Avtorji: | ID Sazzad, Mahmud (Avtor) ID Suzuki, Kiichi (Avtor) ID Fakulteta za gradbeništvo, prometno inženirstvo in arhitekturo Univerze v Mariboru (Lastnik avtorskih pravic) |
Datoteke: | Acta_geotechnica_Slovenica_2012_Sazzad,_Suzuki_A_comparison_between_conventional_triaxial_and_plane-strain_compression_on_a_particulate.pdf (257,70 KB) MD5: 0E316497EB4C83CE4F018F276F49E3D8 PID: 20.500.12556/dkum/9995c801-74a4-414b-a970-2731b9b7e5bf
http://fgserver3.fg.um.si/journal-ags/2012-2/article-2.asp
|
---|
Jezik: | Angleški jezik |
---|
Vrsta gradiva: | Znanstveno delo |
---|
Tipologija: | 1.01 - Izvirni znanstveni članek |
---|
Organizacija: | FGPA - Fakulteta za gradbeništvo, prometno inženirstvo in arhitekturo
|
---|
Opis: | Granular materials such as sand are subjected to different stress paths depending on the in-situ conditions. For example, a granular system under the foundations experiences conventional triaxial compression (CTC), while it experiences plane-strain compression (PSC) in the case of the embankment of roads. Due to the difference in the stress paths, the behavior of granular materials also becomes different. This paper aims at comparing the behavior of granular materials under CTC and PSC conditions using the 3D discrete-element method (DEM). An isotropically compressed dense sample consisting of 8000 spheres was prepared numerically using periodic boundaries. The CTC and PSC tests were simulated using the same isotropically compressed dense sample to compare and explore the macro- and micro-mechanical responses of granular materials without any bias from the initial fabric of the numerical sample. Qualitatively, the simulated stress-strain responses are consistent with that observed in the experimental studies. The dilatancy index is found to be independent of the stress paths used in the present study. The b value (defined as b = (σ2 − σ3)/(σ1 − σ3) where σ1, σ2 and σ3 are the stresses in the x1 -, x2 - and x3 - directions, respectively) - axial strain curve has a close similarity with the stress ratio - axial strain curve for the PSC test. The evolution of the coordination number and the sliding contact fraction is independent of the stress paths. A link between the macro- and micro-quantities is observed and a unique macro-micro relationship is noticed, regardless of the stress paths applied in this study. |
---|
Ključne besede: | conventional triaxial compression, plane-strain compression, micro response, DEM |
---|
Status publikacije: | Objavljeno |
---|
Verzija publikacije: | Objavljena publikacija |
---|
Leto izida: | 2012 |
---|
Št. strani: | str. 17-23 |
---|
Številčenje: | Letn. 9, št. 2 |
---|
PID: | 20.500.12556/DKUM-70778  |
---|
ISSN: | 1854-0171 |
---|
UDK: | 550.3:539.58 |
---|
COBISS.SI-ID: | 270603776  |
---|
ISSN pri članku: | 1854-0171 |
---|
NUK URN: | URN:SI:UM:DK:JI7PB5ZH |
---|
Avtorske pravice: | Fakulteta za gradbeništvo, prometno inženirstvo in arhitekturo Univerze v Mariboru |
---|
Datum objave v DKUM: | 13.06.2018 |
---|
Število ogledov: | 1237 |
---|
Število prenosov: | 67 |
---|
Metapodatki: |  |
---|
Področja: | Ostalo
|
---|
:
|
Kopiraj citat |
---|
| | | Skupna ocena: | (0 glasov) |
---|
Vaša ocena: | Ocenjevanje je dovoljeno samo prijavljenim uporabnikom. |
---|
Objavi na: |  |
---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |