| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Show document

Title:Orodje za brizganje držala cevnih varovalk
Authors:Grah, Neven (Author)
Belšak, Aleš (Mentor) More about this mentor... New window
Brajlih, Tomaž (Co-mentor)
Files:.pdf VS_Grah_Neven_2019.pdf (3,13 MB)
 
Language:Slovenian
Work type:Bachelor thesis/paper (mb11)
Typology:2.11 - Undergraduate Thesis
Organization:FS - Faculty of Mechanical Engineering
Abstract:Diplomska naloga opisuje konstrukcijo orodja za brizganje držala cevnih varovalk. Tema je bila izbrana na podlagi potrebe po novem orodju med praktičnim usposabljanjem v podjetju Elektromaterial Lendava d.o.o. V uvodu je predstavljen problem, cilji in tudi omejitve, ki so se pojavile pri izdelavi orodja. Drugi del diplomske naloge pa obsega opis izdelave orodja, in sicer od konstruiranja do izdelave končnega produkta. Pri tem so natančno opisani vsi postopki, ki so bili izvedeni pri izdelavi orodja. Prav tako pa je narejena vsa tehniška dokumentacija, ki je potrebna za izdelavo končnega izdelka.
Keywords:Orodje, Žična erozija, Brizganje
Year of publishing:2019
Source:Maribor
NUK URN:URN:SI:UM:DK:2V2R2STE
License:CC BY-NC-ND 4.0
This work is available under this license: Creative Commons Attribution Non-Commercial No Derivatives 4.0 International
Views:125
Downloads:11
Metadata:XML RDF-CHPDL DC-XML DC-RDF
Categories:KTFMB - FS
:
  
Average score:(0 votes)
Your score:Voting is allowed only for logged in users.
Share:AddThis
AddThis uses cookies that require your consent. Edit consent...

Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

Secondary language

Language:English
Title:Injection tool for holder of pipe fuses
Abstract:Thesis describes the construction of mould for injections of pipe fuse holders. Title was chosen on basis of need for a new mould while doing practical training at company Elektromaterial Lendava d.o.o. The problem, goal and limits, which came up at creating the mould are presented in the introduction. Second part of the thesis covers the description of manufacturing the mould. From the construction to the creation of the final product. In doing so all the procedures are precisely described that were used for manufacturing the mould. Also all the technical documentation that is required to manufacture the final product is made.
Keywords:Tool, Wire electrical discharge machining, Injection


Comments

Leave comment

You have to log in to leave a comment.

Comments (0)
0 - 0 / 0
 
There are no comments!

Back
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica