| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

# Show document

Title: Konstruiranje tlačne posode za kompenzacijo nihanja tlakov : diplomsko delo Kosi, Miha (Author)Glodež, Srečko (Mentor) More about this mentor... DiplomskaNaloga_MihaKosi.pdf (1,07 MB)MD5: 8F01310007F69EB1525D46F19B667E29 Slovenian Bachelor thesis/paper (mb11) 2.11 - Undergraduate Thesis FS - Faculty of Mechanical Engineering V diplomskem delu je predstavljeno konstruiranje tlačne posode za podjetje Silkem d.o.o.. Tlačna posoda je konstruirana po standardu EN 13445. V začetku naloge so predstavljene teoretične osnove tlačnih posod ter standarda EN 13445. V nadaljevanju so podane zahteve za tlačno posodo, ki jih je podalo podjetje ter trdnostni preračun. Predstavljena je tudi analiza modela tlačne posode po metodi končnih elementov. 3D model je izdelan v programski opremi Solidworks2019, simulacije pa so iz vedene v programski opremi Abaqus CAE. tlačne posode, konstruiranje, numerične analize, trdnostni preračun, diplomske naloge 2020 Maribor [M. Kosi] VIII, 29 f. Maribor 621.772.4(043.2) 62956035 223 101 KTFMB - FS

Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

## Secondary language

Language: English Construction of pressure vessel for compensation of pressure fluctuations The diploma thesis presents the construction of a pressure vessel for the company Silkem d.o.o.. The pressure vessel is constructed according to standard EN 13445. At the beginning of the thesis, the theoretical basis of pressure vessels and the standard EN 13445 are presented. The following are the requirements for the pressure vessel given by the company and the strenght calculation. An analysis of the pressure vessel model by the finite element method is also presented. The 3D model is made in Solidworks2019 software, and the simulations are performed in Abaqus CAE software. pressure vessels, construction, numerical analyzes, strenght calculations