| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Show document

Title:Planiranje kapacitet in razmeščanje delovnih mest s pomočjo računalniške podpore
Authors:Lažeta, Simon (Author)
Palčič, Iztok (Mentor) More about this mentor... New window
Ojsteršek, Robert (Co-mentor)
Files:.pdf MAG_Lazeta_Simon_2017.pdf (3,86 MB)
Work type:Master's thesis/paper (mb22)
Typology:2.09 - Master's Thesis
Organization:FS - Faculty of Mechanical Engineering
Abstract:Magistrska naloga se osredotoča na planiranje kapacitet in razmeščanje delovnih mest teoretičnega primera. Temeljni problem magistrske naloge je bil isti teoretični primer rešiti analitično (s pomočjo izračunov planiranja kapacitet in matriko OD-KAM ter trikotno metodo za razmeščanje delovnih mest) in nato aplikativno s pomočjo računalniškega programa Autodesk Factory Design Suite. Ugotovili smo, da se analitični izračun in pridobljeni aplikativni podatki s pomočjo računalniških simulacij razlikujejo. Navedli smo ključne razloge za razliko in podali predloge za odpravo omenjene razlike.
Keywords:planiranje kapacitet, razmeščanje delovnih mest, Autodesk Factory Design Suite
Year of publishing:2017
Publisher:[S. Lažeta]
COBISS_ID:21292054 Link is opened in a new window
License:CC BY-NC-ND 4.0
This work is available under this license: Creative Commons Attribution Non-Commercial No Derivatives 4.0 International
Categories:KTFMB - FS
Average score:(0 votes)
Your score:Voting is allowed only for logged in users.
AddThis uses cookies that require your consent. Edit consent...

Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

Secondary language

Title:Capacity and layout planning with computer added support
Abstract:The master's thesis focuses on the capacity and layout planning of a theoretical example. The basic problem of the master's thesis is to solve the theoretical problem analytically (using the capacity calculation, the FROM – TO matrix and the triangular method for workplace positioning) and then using the Autodesk Factory Design Suite computer program. We have found that there was a difference between the analytical calculations and the data obtained by computer simulations. We have stated the key reasons for the difference and solutions to eliminate these differences.
Keywords:planning capacity, layout planning, Autodesk Factory Design Suite


Leave comment

You have to log in to leave a comment.

Comments (0)
0 - 0 / 0
There are no comments!

Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica