SLO | ENG

Bigger font | Smaller font

Show document

Title:Peč za sintranje mikro objektov
Authors:Bogša, Matjaž (Author)
Gotlih, Karl (Mentor) More about this mentor... New window
Šafarič, Riko (Mentor) More about this mentor... New window
Bratina, Božidar (Co-mentor)
Files:.pdf UN_Bogsa_Matjaz_2017.pdf (1,21 MB)
 
Language:Slovenian
Work type:Bachelor thesis/paper (mb11)
Organization:FS - Faculty of Mechanical Engineering
Abstract:Diplomsko delo opisuje postopek izdelave peči, ki je namenjena sintranju mikrometrskih objektov. Podrobneje je predstavljen proces zasnove in izgradnje regulatorja temperature z vsemi poizkusi, ki smo jih tekom dela izvedli ter dobljenimi rezultati. Metode dela so bile tekom razvoja različne, začeli smo z načrtovanjem in konstrukcijo s pomočjo CAD programa Solidworks, nadaljevali z načrtovanjem vezja, pisanjem programske kode ter zaključili z merjenjem in interpretacijo rezultatov. S pomočjo P regulatorja nam je nihanje temperature na koncu uspelo omejiti na 1 °C podnihaja. Kljub temu, da smo z delovanjem peči zadovoljni, še zmeraj ostaja nekaj pomanjkljivosti, ki ponujajo možnost nadgradnje.
Keywords:regulator temperature, regulacijski pogrešek, prenihaj, izgube
Year of publishing:2017
Source:Maribor
License:CC BY-ND 4.0
This work is available under this license: Creative Commons Attribution No Derivatives 4.0 International
Views:33
Downloads:2
Metadata:XML RDF-CHPDL DC-XML DC-RDF
Categories:KTFMB - FS
:
  
Average score:(0 votes)
Your score:Voting is allowed only for logged in users.
Share:Bookmark and Share

Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

Secondary language

Language:English
Title:Micro-Objects sintring oven
Abstract:The diploma describes the building procedure of an oven, designed for sintering micro-objects. It focuses on the designing and building of a regulator, including all experiments used during the development, and the results we got. During the development, many different methods of work were used. We started with the design and the construction of a model in CAD program Solidworks, continued with circuit design, writing the program code and finished with the measurement and the interpretation of the results. We limited the temperature oscillation to 1 °C below the set temperature, with the P regulator. Despite the fact that, we are satisfied with the results, there are still some downsides that provide room for improvement.
Keywords:temperature controller, error, overshoot, energy loss


Comments

Leave comment

You have to log in to leave a comment.

Comments (0)
0 - 0 / 0
 
There are no comments!

Back
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica