| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Show document

Title:Konstrukcija orodja za brizganje končnika bovdena
Authors:Mlakar, Aljaž (Author)
Pahole, Ivan (Mentor) More about this mentor... New window
Brajlih, Tomaž (Co-mentor)
Files:.pdf VS_Mlakar_Aljaz_2017.pdf (4,18 MB)
 
Language:Slovenian
Work type:Bachelor thesis/paper (mb11)
Typology:2.11 - Undergraduate Thesis
Organization:FS - Faculty of Mechanical Engineering
Abstract:V diplomskem delu je predstavljena izdelava 6-gnezdnega orodja za brizganje kočnika bovdena. Izdelave orodja sem lotil po stopnjah, najprej sem pregledal dokumentacijo z tehničnimi zahtevami, ki nam jo je poslal naročnik orodja. Nato je sledilo; snovanje orodja, modeliranje, priprava delavniških risb, izdelava sestavnih delov, sestava orodja, brizganje izdelkov in nazadnje kontrola kakovosti, ki je morala ustrezati vsem zahtevam. Pri sami izdelavi orodja ni bilo večjih težav, le nekaj manjših zadev, ki smo jih kasneje uspešno odpravili. Orodje se nahaja pri naročniku, kjer deluje brezhibno.
Keywords:konstruiranje, modeliranje, potopna erozija, brizganje plastičnih mas
Year of publishing:2017
Publisher:[A. Mlakar]
Source:Maribor
UDC:621.767:621.793.79(043.2)
COBISS_ID:20883478 Link is opened in a new window
NUK URN:URN:SI:UM:DK:AEFWQYKL
License:CC BY-NC-ND 4.0
This work is available under this license: Creative Commons Attribution Non-Commercial No Derivatives 4.0 International
Views:798
Downloads:185
Metadata:XML RDF-CHPDL DC-XML DC-RDF
Categories:KTFMB - FS
:
  
Average score:(0 votes)
Your score:Voting is allowed only for logged in users.
Share:AddThis
AddThis uses cookies that require your consent. Edit consent...

Hover the mouse pointer over a document title to show the abstract or click on the title to get all document metadata.

Secondary language

Language:English
Title:The construction of the injection tool for bowden end part
Abstract:This thesis describes the production of the 6-nest molding tool used for injecting the bowden end part. I tackled the construction of the tools in stages, beginning by reviewing the documents with technical requirements, that were sent to us by the buyer of the tools. That stage was followed by; designing the tools, modelling, preparation of the construction drawings, construction of needed components, assembling the tools, injecting the products and finally the quality control that had to meet all of the requirements. We stumbled upon no major obstacles while assembling the tools, except for a few minor issues that were later successfully resolved. The tool is now located at the buyers, where it operates flawlessly.
Keywords:design, modelling, submerged erosion, injection moulding


Comments

Leave comment

You have to log in to leave a comment.

Comments (0)
0 - 0 / 0
 
There are no comments!

Back
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica