| Naslov: | Computer-aided analysis of the forging process |
|---|
| Avtorji: | ID Šraml, Matjaž (Avtor)
ID Stupan, Janez (Avtor)
ID Potrč, Iztok (Avtor)
ID Kramberger, Janez (Avtor) |
|---|
| Datoteke: |  http://www.springerlink.com/openurl.asp?genre=article&id=doi:10.1007/s00170-003-1578-1
|
|---|
| Jezik: | Angleški jezik |
|---|
| Vrsta gradiva: | Neznano |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: | FS - Fakulteta za strojništvo
|
|---|
| Opis: | This paper presents computer simulation of the forging process using the finite volume method (FVM). The process of forging is highly non-linear, where both large deformations and continuously changing boundary conditions occur. In most practical cases, the initial billet shape is relatively simple, but the final shape of the end product is often geometrically complex, to the extent that it is commonly obtained using multiple forming stages. Examples of the numerical simulation of the forged pieces provided were created using Msc/SuperForge computer code. The main results of the analysis are deformed shape, temperature, pressure, effective plastic strain, effective stress and forces acting on the die. |
|---|
| Ključne besede: | forging, computer simulation, finite volume method, deformation, stresses, material flow, industrial applications |
|---|
| Leto izida: | 2004 |
|---|
| PID: | 20.500.12556/DKUM-27503  |
|---|
| UDK: | 621.73 |
|---|
| COBISS.SI-ID: | 8547350 |
|---|
| ISSN pri članku: | 0268-3768 |
|---|
| NUK URN: | URN:SI:UM:DK:GMVTMS1O |
|---|
| Datum objave v DKUM: | 01.06.2012 |
|---|
| Število ogledov: | 2169 |
|---|
| Število prenosov: | 114 |
|---|
| Metapodatki: |    |
|---|
| Področja: | Ostalo
|
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Skupna ocena: | (0 glasov) |
|---|
| Vaša ocena: | Ocenjevanje je dovoljeno samo prijavljenim uporabnikom. |
|---|
| Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
