SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Izpis gradiva

Naslov:Thread gauge calibration for industrial applications
Avtorji:Primožič Merkač, Tadeja (Avtor)
Ačko, Bojan (Avtor)
Datoteke:URL http://www.sv-jme.eu/scripts/download.php?file=/data/upload/2010/10/05_2010_036_Primozic_2k.pdf
 
Jezik:Angleški jezik
Vrsta gradiva:Neznano ()
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Opis:There are two most commonly used methods for calibration of thread rings, with different measuring uncertainty. The method of mechanical sensing with two balls is mostly used on one-axial measuring machines and on coordinate measuring machines. However, the method of calculating the core diameter of the thread ring combined with the technique of adaptation (in accordance with the method of the smallest squares) is used on the profile scanner. The required tolerances, which are very narrow for adjustable and laboratory thread ring, so the measuring uncertainty may be too high when using the method of mechanical sensing with two balls, and the low quality of some control rings, are the decisive factors for choosing an appropriate method in the industry. This also depends on the laboratoryćs capability of executing a specific method. The measurements of the core diameter of thread rings, which are the main topic of this article, were included into an international inter-comparison in which the main subject was the same thread ring as the one mentioned in this article.
Ključne besede:thread ring gauge, calibration, pitch diameter, measurement uncertainty, dimensional measurements
Leto izida:2010
UDK:621.7.08:621.99
URN:URN:SI:UM:DK:DQQXG7FD
COBISS_ID:14586646 Povezava se odpre v novem oknu
ISSN pri članku:0039-2480
Število ogledov:1102
Število prenosov:16
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
Področja:Ostalo
:
  
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
Objavi na:AddThis
AddThis uporablja piškotke, za katere potrebujemo vaše privoljenje.
Uredi privoljenje...

Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:Strojniški vestnik
Skrajšan naslov:Stroj. vestn.
Založnik:Zveza strojnih inženirjev in tehnikov Slovenije [et al.]
ISSN:0039-2480
COBISS.SI-ID:762116 Novo okno

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici