| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Rheological properties of marine sediments from the port of Koper
Jasna Smolar, Matej Maček, Ana Petkovšek, 2016, izvirni znanstveni članek

Opis: Subaqueous, fine-grained, cohesive sediments are continuously fluidized by waves and other disturbances that cause their movement, which can be described with numerical models incorporating rheological parameters. The rheological behaviour depends on the soil (solid) type, the volume concentration, the salinity and the testing methods. In this study, rheological investigations of marine sediments from the Port of Koper were carried out by using two coaxial cylinder rheometers (DV3T HB, Brookfield and ConTec Viscometer 5). The influence of the specimen volume, the size of the gap and the type of measuring spindles were analysed and compared. The measured data were evaluated using the Bingham model. For each data set, the boundary between the sheared (“fluid”) and the un-sheared (“solid”) material was calculated and then the calculated boundary was used instead of the outer radius of the cylinder for the evaluation of the rheological parameters, where necessary. A good comparison of the results was found when using this approach. The results are also in agreement with the literature data. The ConTec Viscometer 5, primarily designed for mortars and concrete, was shown to be also suitable for the investigation of sediments.
Ključne besede: marine sediments, Bingham model, yield stress, plastic viscosity, coaxial cylinder rheometer, plug flow, Bay of Koper
Objavljeno v DKUM: 18.06.2018; Ogledov: 1252; Prenosov: 80
.pdf Celotno besedilo (709,57 KB)
Gradivo ima več datotek! Več...

2.
Modeling of forming efficiency using genetic programming
Miran Brezočnik, Jože Balič, Zlatko Kampuš, 2001, izvirni znanstveni članek

Opis: This paper proposes new approach for modeling of various processes in metal-forming industry. As an example, we demonstrate the use of genetic programming (GP) for modeling of forming efficiency. The forming efficiency is a basis for determination of yield stress which is the fundamental characteristic of metallic materials. Several different genetically evolved models for forming efficiency on the basis of experimental data for learning were discovered. The obtained models (equations) differ in size, shape, complexity and precision of solutions. In one run out of many runs of our GP system the well-known equation of Siebel was obtained. This fact leads us to opinion that GP is a very powerful evolutionary optimization method appropriate not only for modeling of forming efficiency but also for modeling of many other processes in metal-forming industry.
Ključne besede: metal forming, yield stress, forming efficiency, mathematical modeling, adaptation, genetic methods, genetic algorithm, genetic programming, artificial intelligence, process optimisation
Objavljeno v DKUM: 01.06.2012; Ogledov: 2212; Prenosov: 123
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.05 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici