SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Cyclic liquefaction potential of lacustrine carbonate from Julian Alps
Bojan Žlender, Stanislav Lenart, izvirni znanstveni članek

Opis: This paper presents the liquefaction studies of lacustrine carbonate silt from the Julian Alp landslide Stože. Geological conditions of the region and geomechanical characteristics of the ground were investigated. The research project was performed with the intention to determine the effects of cyclic loading on lacustrine carbonate silt. Investigation with 77 cyclic triaxial tests was performed on universal triaxial apparatus Wykeham Farrance UP 100 TR, in the Laboratory of soil mechanics, Faculty of Civil Engineering, University of Maribor. The essential equipment comprises cylindrical triaxial apparatus with a cell, a press with appurtenant electro-mechanic equipment, measuring equipment, and computer hardware and software equipment. Specimens with dimensions of height = 140 mm and diameter = 70 mm were saturated, then subjected to the arbitrary initial isotropic stress state and consolidated with vertical and radial draining, and then loaded with distortional loading of chosen dynamical axial force (frequency f = 1 Hz). A set of tests with a spectrum of different stress states and cyclic loading were performed. This research showed that lacustrine carbonate silt is a highly sensitive material.The resistance to liquefaction was somewhat higher than that of typical clean sand, but a perceivable excess pore pressure generation, which causes the decrease of strength parameters, was noticed. Test results of cyclic triaxial tests indicate dynamic characteristics of lacustrine carbonate silt and wide applicability of the test method.
Ključne besede: civil engineering, geomechanics, soil investigations, lacustrine carbonate silt, cyclic triaxial tests, liquefaction potential, shear modulus, damping ratio, cyclic stress ratio, pore pressure ratio
Objavljeno: 15.05.2018; Ogledov: 132; Prenosov: 6
.pdf Celotno besedilo (1,53 MB)

2.
Experimental research on variation of pore water pressure in constant rate of strain consolidation test
Hojjat Ahmadi, Hassan Rahimi, Abbas Soroush, Claes Alén, 2014, izvirni znanstveni članek

Opis: Constant rate of strain (CRS) consolidation is a rapid test method which is used for determination of compressibility of clayey soils. In a CRS test, the appropriate strain rate is selected based on pore water pressure ratio, i.e. the ratio of pore pressure to total stress. In the present study, to investigate the effect of strain rate on variation of pore water pressure ratio, four different clay samples of different plasticity were tested by CRS apparatus. The results of the experiments showed that the trend of variation of pore water pressure is dependent on the drained water flow regime which may be either Darcy or non-Darcy. The results also indicated that the plasticity of clay does not have considerable effect on variation of pore water pressure.
Ključne besede: constant rate of strain, consolidation, pore water pressure ratio, soil plasticity, Darcy and non-Darcy flow
Objavljeno: 14.06.2018; Ogledov: 42; Prenosov: 3
.pdf Celotno besedilo (576,58 KB)

Iskanje izvedeno v 0.03 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici