| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 1 / 1
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
The use of water atomisation for the production of frits
Tadej Lešer, Ivan Anžel, Andreja Goršek, 2015, izvirni znanstveni članek

Opis: The production of powder materials from melts is usually done by atomisation. In our research two different frits were successfully produced using water atomisation technique. An overall assessment of the powders showed that the sizes of particles and their morphologies are determined mainly by the chemical compositions of the frits and atomisation parameters. The sizes of the particles depend on the viscosities of the frits, which is governed by the melt superheating during the experimental trials, orifice diameter and interactions between droplets and particles during additional stages after primary atomisation, which were controlled by water pressure. The morphologies of the particles depend on the relationships between the times of solidification and sphereoidisation and on the interactions between the particles.
Ključne besede: water atomisation, microstructure, spheroidisation, frits
Objavljeno v DKUM: 03.07.2017; Ogledov: 2365; Prenosov: 116
.pdf Celotno besedilo (260,23 KB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.04 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici