SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Cyclic liquefaction potential of lacustrine carbonate from Julian Alps
Bojan Žlender, Stanislav Lenart, izvirni znanstveni članek

Opis: This paper presents the liquefaction studies of lacustrine carbonate silt from the Julian Alp landslide Stože. Geological conditions of the region and geomechanical characteristics of the ground were investigated. The research project was performed with the intention to determine the effects of cyclic loading on lacustrine carbonate silt. Investigation with 77 cyclic triaxial tests was performed on universal triaxial apparatus Wykeham Farrance UP 100 TR, in the Laboratory of soil mechanics, Faculty of Civil Engineering, University of Maribor. The essential equipment comprises cylindrical triaxial apparatus with a cell, a press with appurtenant electro-mechanic equipment, measuring equipment, and computer hardware and software equipment. Specimens with dimensions of height = 140 mm and diameter = 70 mm were saturated, then subjected to the arbitrary initial isotropic stress state and consolidated with vertical and radial draining, and then loaded with distortional loading of chosen dynamical axial force (frequency f = 1 Hz). A set of tests with a spectrum of different stress states and cyclic loading were performed. This research showed that lacustrine carbonate silt is a highly sensitive material.The resistance to liquefaction was somewhat higher than that of typical clean sand, but a perceivable excess pore pressure generation, which causes the decrease of strength parameters, was noticed. Test results of cyclic triaxial tests indicate dynamic characteristics of lacustrine carbonate silt and wide applicability of the test method.
Ključne besede: civil engineering, geomechanics, soil investigations, lacustrine carbonate silt, cyclic triaxial tests, liquefaction potential, shear modulus, damping ratio, cyclic stress ratio, pore pressure ratio
Objavljeno: 15.05.2018; Ogledov: 71; Prenosov: 1
.pdf Celotno besedilo (1,53 MB)

2.
The dynamic properties of the snail soil from the Ljubljana marsh
Bojan Žlender, Ludvik Trauner, 2007, izvirni znanstveni članek

Opis: A series of cyclic triaxial tests was performed on snail-soil samples with different porosities. The cyclic loading was performed with a Wykeham Farrance cyclic triaxial system. The investigation was based on a series of tests in which the following conditions were varied: the initial effective pressures (50, 100, and 150 kPa), the void ratio after consolidation (2.0–1.2) and the cyclic loading expressed by the cyclic stress ratio CSR (0.1–1.0). Measurements were made of the stress, the deformation and the pore-water pressure. The results of the tests show that interdependency exists between the geomechanical characteristics and the porosity. These relationships can be expressed as functions of the density, the porosity or the water content. It is evident from the results that the changes in the coefficient of permeability, the coefficient of consolidation, and the coefficient of volume compressibility are non-linear with respect to the changes in the porosity. However, the changes at high porosity are much greater than the changes at low porosity, and the changes of the mechanical parameters, such as the Young’s modulus, Poisson’s ratio, and the friction angle, are indistinct and almost linear at lower changes of porosity, and after that become non-linear. The initial void ratio e is extremely high and the snail soil is liquid after consolidation; a volume strain of εvol > 16 % is needed for the plastic limit state. The chemical and mineral composition, the particle size distribution and the remains of micro-organisms in the snail soil are constants. In addition, the specific surface is independent of the porosity and the density or unit weight, the porosity and the volume strain are in the well-known correlation. The performed cyclic triaxial tests show the dynamic characteristics of the snail soil and the influence of the porosity on the cyclic loading strength. The snail soil was recognized as a highly sensitive material. A large strain appears after the initial cycles. The pore pressure, increases already during the first cycle, to the hydrostatic part of the cyclic loading, or more (depending on CSR). The damping ratio increases exponentially with strain, after some cycles it reach its maximum value, and after that it decreases to the asymptotic value. The reason for such behaviour is the large deformation. The maximum and asymptotic values of the damping ratio are a changed minimum with a void ratio. There is obviously no influence of the porosity on the damping ratio. The shear modulus is described in relation to shear strain. The increasing of the pore pressure is independent of the porosity until it reaches some value of the pore-pressure ratio (>0.7). Similarly, the increasing of the shear strain becomes dependent on the void ratio until it reaches some particular value of the shear strain (>3%). The deformation and failure lines for the different porosities are determined from the relationship between the shear stress and the effective stress at some shear strain, after 10 cycles. The relationships between the shear stress and the effective stress at some value of the pore-pressure ratio are expressed in a similar way. Two kinds of criteria were used to determine the triggering of liquefaction during the cyclic triaxial tests: first, when the pore pressure becomes equal to the effective confining pressure, and, second, when the axial strain reaches 5% of the double amplitude.
Ključne besede: snail soil, cyclic triaxial test, porosity, permeability, consolidation, Young’s modulus, shear modulus, damping ratio, Poisson’s ratio, friction angle
Objavljeno: 18.05.2018; Ogledov: 330; Prenosov: 2
.pdf Celotno besedilo (479,11 KB)

Iskanje izvedeno v 0.01 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici