| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Search the digital library catalog Help

Query: search in
search in
search in
search in
* old and bologna study programme


1 - 2 / 2
First pagePrevious page1Next pageLast page
Fatigue crack initiation from microstructurally small Vickers indentations
Tomaž Vuherer, Andrej Godina, Zijah Burzić, Vladimir Gliha, 2007, original scientific article

Abstract: The resistivity of coarse grain steel against crack initiation in the presence of micro defects is discussed. Samples of material with martensitic microstructure were prepared by adequate thermal treatment. Microstructurally small Vickers indentations were used as an artificial micro defect. The compressive residual stresses are due to the irreversibility of plastic deformation. The moment of indenting enables to prepare samples with and without effects of residual stresses. The stress level for crack initiation depends on the actual indentation size. The location of initiated cracks is affected by the presence and character of residual stresses.
Keywords: welded joints, micro defect, coarse grain HAZ, crack initiation, crack growth, stress concentration, fatigue limit, Vickers, residual stresses
Published: 03.07.2017; Views: 678; Downloads: 84
.pdf Full text (1,02 MB)
This document has many files! More...

Some factors affecting fatigue resistance of welds
Vladimir Gliha, Zijah Burzić, Tomaž Vuherer, 2010, published scientific conference contribution

Abstract: The fatigue strength of polycrystalline metals is hardness and defect size dependent. The fatigue strength of welds depends on the size of grains and actual local mean stress, too. Local mean stress is influenced by the global R-ratio and static preloading. The welds in the as-welded condition are pre-stressed due to the existence of welding residual stresses. The sign and magnitude of residual stresses depend on the welding conditions. Changes of residual stresses, hardness and defect size are experimentally determined in the present work. Samples of studied metals are prepared by using either thermal cycle simulator or laboratory furnace and water quenching. The methods of microstructure preparation and type of load result in actual local R-ratio at the used weld toe models. Specimens are cyclic loaded in the similar way as steel at the weld toe. The bottom of the notch is either defect-free or defected by Vickers indentation. Final results show that coarser grain and higher local R-ratios lower the fatigue strength of welds.
Keywords: CrNiMo steels, weld, fatigue resistance, heat-affected zone, small weld defects
Published: 31.05.2012; Views: 1179; Downloads: 18
URL Link to full text

Search done in 0.06 sec.
Back to top
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica