Iskanje po katalogu digitalne knjižnice

Opis: Water hammer phenomena in pipelines can induce significant transient pressure surges, leading to structural failures and operational inefficiencies. This study presents a comparative analyzis of two numerical approaches for simulating water hammer: a one-dimensional (1D) inviscid model with added friction based on the Euler equations and the method of characteristics, and a three-dimensional (3D) viscous model utilizing the Navier-Stokes equations in OpenFOAM. Benchmarking problems are solved first, then both methods are used to study a 3.4 km long DN400 pipeline subject to sudden pump failure by analyzing pressure surges, cavitation, and water column separation. The 1D model effectively predicts transient pressure waves and cavitation conditions with minimal computational cost, while the 3D model provides a detailed representation of multiphase flow dynamics, including cavitation bubble growth and collapse via the volume of fluid method. To mitigate adverse effects, a dynamic combination air valve is introduced, and its effectiveness in reducing pressure surges and cavitation is demonstrated. The results highlight the trade-offs between computational efficiency and accuracy in modelling water hammer events and underscore the importance of protective measures in pipeline systems.
Ključne besede: water hammer, cavitation, water column separation, CFD, Euler equation, Navier-Stokes equations, OpenFOAM, method of characteristics
Objavljeno v DKUM: 09.12.2025; Ogledov: 0; Prenosov: 3
Celotno besedilo (3,18 MB)
Gradivo ima več datotek! Več...

Opis: In filling lines equipped with membrane separation devices in the form of filters energy, consumption is only one of the important working parameters, the other being sustainable filter performance in terms of separation efficiency. As the filling line is typically equipped with a valve, intermittent operation of the filter is an important form of its use. Whereas the overall energy consumption of the filtration process is governed by the continuous operation mode, the intermittent mode, characterised by opening/closing of the valve, contributes most to problems of filter failure, i.e., the breakthrough of filtered particles through the membrane. A model for determination of the energy intake of a microfiltration membrane during the opening and closing of a valve is presented in this work. The model is based on computational analysis of the pressure wave signals recorded during the opening/closing of the valve using Fourier transform, and expressed in a nondimensional filter area specific energy intake form. The model is applied to a case of constant pressure dead-end microfiltration with three filter types: a single membrane filter, a stacked filter and a pleated filter with filtration surface areas ranging from 17.7 cm2 to 2000 cm2. Both clean filters, as well as partially clogged filter cases are taken into account. Second order polynomial models of the energy intake are developed and evaluated based on extensive analysis of the experimental data. The analysis of energy intake results show that the largest energy intake was observed for the clean filter case. When membrane fouling occurs at the constant flow rate values it leads to larger energy intake, however, due to a decreasing specific flow rate during fouling these values do not exceed the clean filter case.
Ključne besede: membrane filtration, water hammer effect, membrane energy intake, filter clogging
Objavljeno v DKUM: 28.03.2025; Ogledov: 0; Prenosov: 8
Celotno besedilo (4,01 MB)
Gradivo ima več datotek! Več...