| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Computational model for analysing the tooth deflection of polymer gears
Aljaž Ignatijev, Srečko Glodež, Janez Kramberger, 2024, izvirni znanstveni članek

Opis: A computational model for analysing the tooth deflection of polymer gears is presented in this paper. Because polymer gears have less stiffness compared to metal gears, the proposed approach considers a comprehensive analysis to determine the most suitable numerical model, i.e., the number of teeth that should be modelled for a given gear’s geometry and material. The developed computational model has been evaluated using a spur gear pair, where the pinion made of POM was meshed with a support gear made of steel. Material properties were assigned with linear elastic characteristics for the gear, while the pinion was characterised by hyperelastic properties using POM material. Furthermore, a nonlubricated frictional contact between the gear and pinion was considered in the numerical computations. The computational results that were obtained were compared to the empirical results according to VDI 2736 guidelines. Here, the computational approach showed more accurate results due to the hyperelastic material characteristics of POM and the simulation of multiple teeth meshing. However, VDI 2736 calculation showed comparability with the computational results, with a slightly larger deviation at higher loads. In this respect, the proposed computational approach is more suitable for analysing the tooth deflection of polymer gears under higher loads.
Ključne besede: polymer gears, tooth deflection, computational modelling
Objavljeno v DKUM: 19.03.2024; Ogledov: 88; Prenosov: 7
.pdf Celotno besedilo (3,57 MB)
Gradivo ima več datotek! Več...

2.
The influence of surface coatings on the tooth tip deflection of polymer gears
Boštjan Trobentar, Srečko Glodež, Jože Flašker, Boštjan Zafošnik, 2016, izvirni znanstveni članek

Opis: When designing gear drives made of polymer, the tooth tip deflection is a crucial parameter in respect to the proper gear drive operation. Excessive tooth tip deflection can lead to serious disturbances of gear meshing and consequently to increased noise and wear of the teeth flanks. In such cases the tooth tip deflection can be reduced through the use of stiff surface coatings on the tooth flanks. In this paper the influence of different coating materials and thicknesses on the tooth tip deflection of polymer gears is analysed using comprehensive finite element computational analysis. The numerical results obtained are then used to define an approximate equation for the calculation of gear tooth tip deflection for the coating material used and the thickness of the surface coating layer. The results show that the tooth tip deflection decreases with large values of the coating material Young’s modulus and with the coating layer thickness.
Ključne besede: polymer gears, surface coatings, tooth deflection, numerical analysis
Objavljeno v DKUM: 27.03.2017; Ogledov: 1600; Prenosov: 394
.pdf Celotno besedilo (578,86 KB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.08 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici