| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 1 / 1
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Prediction of surface roughness with genetic programming
Miran Brezočnik, Miha Kovačič, Mirko Ficko, 2004, izvirni znanstveni članek

Opis: In this paper we propose genetic programming to predict surface roughness in end-milling. Two independent data sets were obtained on the basis of measurement: training data set and testing data set. Spindle speed, feed rate,depth of cut, and vibrations are used as independent input variables (parameters), while surface roughness as dependent output variable. On the basis of training data set, different models for surface roughness were developed by genetic programming. Accuracy of the best model was proved with the testing data. It was established that the surface roughness is most influenced by the feed rate, whereas the vibrations increase the prediction accuracy.
Ključne besede: end milling, surface roughness, prediction of surface roughness, genetic programming
Objavljeno: 01.06.2012; Ogledov: 1037; Prenosov: 75
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.05 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici