Iskanje po katalogu digitalne knjižnice

Opis: The primary objective of this paper is to present a dynamic photovoltaic/thermal collector model in combination with a thermal energy storage tank. The added value of the proposed model is the use and integration of existing dynamic models for describing the entire photovoltaic/thermal system. The presented model was validated using measurements on the experimental system located at the Institute of Energy Technology, Faculty of Energy Technology, University of Maribor. The validation was carried out based on three different weather conditions—sunny, cloudy, and overcast. The validation results were evaluated using the normalized root mean square error and mean absolute percentage error for the temperature and output power of the photovoltaic/thermal collector and the temperature of the thermal energy storage tank. The model results concurred with the measurements, as the average mean absolute percentage error values for the temperature and output power of the photovoltaic/thermal collector and thermal energy storage tank temperature were 5.82%, 1.51%, and 7.58% respectively.
Ključne besede: photovoltaic/thermal collector, thermal energy storage tank, dynamic modeling, temperature distribution, output power
Objavljeno v DKUM: 13.11.2023; Ogledov: 318; Prenosov: 35
Celotno besedilo (8,22 MB)
Gradivo ima več datotek! Več...

Opis: The focus of this Master's thesis was to increase the output-power density of a fractional-horsepower BLDC drive. Different stator segmentation topologies were analyzed and evaluated for this purpose. The presented analysis was performed by using various models with different complexity levels, where a Magnetic Equivalent Circuit (MEC) model and a 2D transient Finite Element Method (FEM) model combined with a power-loss model, were applied systematically. Characteristic behavior of the BLDC drive was obtained in this way. The models were validated with measurement results obtained on an experimental test drive system. The influence of the weakening of the magnetic flux density and flux linkage, due to segmentation were analyzed based on the validated models. Furthermore, the increase of the thermal-stable output power and efficiency was rated, due to the consequently higher slot fill factor. Lastly, a detailed iron-loss analysis was performed for different stator topologies. The performed analysis showed that segmentation of the stator can enable a significant increase of the output power of the discussed BLDC drives, where the positive effects of segmentation outweigh the negative ones from the electromagnetic point of view. Segmentation, however, also impacts other domains, such as Mechanical and Thermal, which was out of the scope of this thesis, and will be performed in the future.
Ključne besede: fractional-horsepower BLDC drive, stator segmentation, fill factor increase, thermal-stable output power, Finite Element Method model
Objavljeno v DKUM: 17.11.2020; Ogledov: 1373; Prenosov: 40
Celotno besedilo (1,69 MB)