| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
Compost leachate treatment using polyaluminium chloride and nanofiltration
Marjana Simonič, 2017, izvirni znanstveni članek

Opis: Laboratory scale filtration tests utilizing leachate were conducted to investigate fouling and filtration performance of nanofiltration membranes. The work presented in this study is conducted on real samples rather than model water. Physico-chemical analyses showed that the leachate contained a lot of organic substances, exceeding 20000 mg/L O2 expressed as chemical oxygen demand. Proper pre-treatment method must be chosen in order to reduce fouling index. Coagulation pre-treatment using poly-aluminium chloride was chosen. Two thin film polysulfone membranes were used, purchased by Osmonic Desal. The focus of this research is to assess the influence of the particle size and zeta-potential of the colloidal fraction in leachate on nanofiltration performance. The isoelectric point of both membranes was 4.7 and 4.3, respectively. The fouled membranes were negatively charged over the pH range with isoelectric point shifting to the left (lower pH) indicating the foulant material mainly not charged. It was confirmed by its zeta-potential, measured at -2 mV.
Ključne besede: compost leachate, coagulation, nanofiltration, zeta potential
Objavljeno: 29.06.2017; Ogledov: 917; Prenosov: 266
.pdf Celotno besedilo (1,86 MB)
Gradivo ima več datotek! Več...

The removal of reactive dye printing compounds using nanofiltration
Irena Petrinić, Niels Peder Raj Andersen, Sonja Šostar-Turk, Alenka Majcen Le Marechal, 2007, izvirni znanstveni članek

Opis: A synthetically prepared reactive dye print wastewater, mimicking real wastewater obtained from a local textile mill, was treated by nanofiltration using an NFT-50 membrane in a plate and frame module configuration at different cross-flow velocities (0.4, 0.6 and 0.8 m/s) and pressures (2-15 bar). The nanofiltration membrane was evaluated for membrane fouling, permeate flux and its suitability for removing colour, conductivity, Na+ ions and COD as a function of operating pressure and feed concentration. The permeate separation efficiency was monitored by measuring the removal efficiency of colour, conductivity, Na+ ions and COD retention. The membrane achieved high dye retention for each of the four dyes (from 99.4 to 99.9%) and electrolytes used (63-73%). The retention of organic substances varied between 20 and 50%, depending on the pressure used; higher retentions were achieved at higher pressure and by using higher cross-flow velocities.
Ključne besede: nanofiltration, nanofitration membranes, wastewater after reactive printing, reactive dye, concentration polarization
Objavljeno: 01.06.2012; Ogledov: 1312; Prenosov: 75
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.06 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici