| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 3 / 3
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
2.
Microstructural and phase analysis of CuAlNi shape-memory alloy after continuous casting
Mirko Gojić, Stjepan Kožuh, Ivan Anžel, Gorazd Lojen, Ivana Ivanić, Borut Kosec, 2013, izvirni znanstveni članek

Opis: The results of the characterization of a CuAlNi shape-memory alloy after continuous casting technology are shown. Using this procedure a bar with a diameter of 8 mm was manufactured. After solidification of the alloy the microstructure characterization was carried out using optic microscopy (OM), scanning electron microscopy (SEM), differential scanning calorimetry (DSC) and X-ray diffraction (XRD) methods. Our results showed that the as-cast alloy consisted of the parent β1 and β1’ martensite phases. The martensite phase primary as the needle-like inside grains was observed. Martensite laths have different orientations inside particular grains. It was found that the average grains size is 98.78 µm. The grain diameter near to the external surface is higher than in the center. The average hardness of the alloy was 275 HV1.
Ključne besede: shape memory alloys, martensite, continuous casting, grain size
Objavljeno v DKUM: 16.03.2017; Ogledov: 1149; Prenosov: 117
.pdf Celotno besedilo (1,28 MB)
Gradivo ima več datotek! Več...

3.
Vloga in nastanek mikrostrukturnih sestavin M-A v zvarnih spojih maloogljičnih visokotrdnostnih konstrukcijskih jekel
Zdravko Praunseis, Masao Toyoda, Alojz Križman, Mitsuru Ohata, 2001, pregledni znanstveni članek

Opis: The existence of martensite-austenite constituents in the weld metal and heat-affected zone seriously reduces the fracture toughness of the welded joint. Therefore, we have investigated the formation of the martensite-austenite constituents when high-strength low-alloy steel is welded with a high heat input or using multi-pass welding. This paper deals with the effects of martensite-austenite constituents on the fracture toughness, the metallurgical features of the martensite-austenite constituents, and the prevention and elimination of the martensite-austenite constituents in the welded joints.
Ključne besede: arc welding, high-strength low-alloy steels, microstructure, martensite-austenite constituents, weld metal, heat-affected zone, cooling rate
Objavljeno v DKUM: 01.06.2012; Ogledov: 2118; Prenosov: 125
.pdf Celotno besedilo (985,12 KB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 1.86 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici