1. Experimental investigation review of biodiesel usage in bus diesel engineBreda Kegl, Marko Kegl, 2017, izvirni znanstveni članek Opis: This paper assembles and analyses extensive experimental research work conducted for several years in relation to biodiesel usage in a MAN bus Diesel engine with M injection system. At first the most important properties of the actually used neat rapeseed biodiesel fuel and its blends with mineral diesel are discussed and compared to that of mineral diesel. Then the injection, fuel spray, and engine characteristics for various considered fuel blends are compared at various ambient conditions, with special emphasis on the influence of low temperature on fueling. Furthermore, for each tested fuel the optimal injection pump timing is determined. The obtained optimal injection pump timings for individual fuels are then used to determine and discuss the most important injection and combustion characteristics, engine performance, as well as the emission, economy, and tribology characteristics of the engine at all modes of emission test cycles test. The results show that for each tested fuel it is possible to find the optimized injection pump timing, which enables acceptable engine characteristics at all modes of the emission test cycles test.
Ključne besede: bus diesel engine, fuel injection, fuel spray, combustion, emission, engine performance, tribology characteristics, optimized injection pump timing
Objavljeno v DKUM: 07.07.2017; Ogledov: 1657; Prenosov: 417
 Celotno besedilo (3,81 MB)
Gradivo ima več datotek! Več... |
2. Influence of biodiesel on injection, fuel spray, and engine characteristicsBreda Kegl, Stanislav Pehan, 2008, izvirni znanstveni članek Opis: This paper discusses the influence of biodiesel on the injection, spray, and engine characteristics with the aim to reduce harmful emissions. The considered engine is a bus diesel engine with injection M system. The injection, fuel spray, and engine characteristics, obtained with biodiesel, are compared to those obtained with mineral diesel under peak torque and ratedconditions. The considered fuel is neat biodiesel from rapeseed oil. Its density, viscosity, surface tension, and sound velocity are determined experimentally and compared to those of mineral diesel. The experimentally obtained results are used to analyze the most important injection, fuel spray, and engine characteristics. Furthermore, the influence of biodiesel usage on lubrication is presented briefly. The results indicate that, by using biodiesel, harmful emissions (NOx, CO, HC, smoke, and PM) can be reduced to some extent by adjusting the injection pump timing properly while keeping other engine characteristics within acceptable limits. Furthermore, the results indicate better lubrication conditions when biodiesel is used.
Ključne besede: biodiesel, diesel engine, injection characteristics, fuel spray, emission, lubrication
Objavljeno v DKUM: 31.05.2012; Ogledov: 1954; Prenosov: 398
Celotno besedilo (1,50 MB)
Gradivo ima več datotek! Več... |
3. Experimental analysis of injection characteristics using biodiesel fuelBreda Kegl, Aleš Hribernik, 2006, izvirni znanstveni članek Opis: This paper deals with injection characteristics using different fuels at different fuel temperatures. The fuels under consideration are neat biodiesel from rapeseed oil and some blends with diesel as well as neat mineral diesel D2. The fuel and fuel temperature influences are investigated experimentally in the mechanically controlled diesel fuel injection M system. At first, attention is focused on the injection characteristics, especially on fuelling, mean injection rate, mean injection pressure, injection timing, injection delay, and injection duration, which influence the most important engine characteristics. Furthermore, the influence of fuel temperature is investigated. On the basis of the measurements of pressure drop through the fuel filter, the minimum fuel temperature for safe engine operation is determined.
Ključne besede: internal combustion engines, fuel blends, biodiesel fuel, temperature influence, injection characteristics
Objavljeno v DKUM: 31.05.2012; Ogledov: 1840; Prenosov: 107
 Povezava na celotno besedilo |
