| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
An integrity analysis of washing machine holders
Nenad Gubeljak, Matej Mejač, Jožef Predan, 2007, izvirni znanstveni članek

Opis: The paper deals with structure integrity analysis of the holder for the carrying cross of a washing machine drum. Premature fracture of the holder occurred between mechanical sustainable tests of washing machine in the factory. In order to prevent fracture, the task was to determine the reasons for premature fracture of the holder and to estimate the suitability of the new design of the holder cross. Input data for structure integriry analysis were obtained by material by mechanical testing of used materials. Stress and strain analysis of holder limit load was performed by finite element modeling of holder. Dynamic tests of holders with two different thicknesses were done on a servo-hydraulic machine in order to find dynamical strength and endurance of holder. Fracture behaviour of holders is defined as initiation and propagation of crack. The obtained behaviour confirmed that the new design of holders reduces stress concentration in the critical region. Consequently, the new holder subjected to the same dynamic load can endure a higher number of cycles until breakage. The total number of cycles overcomes industrial testing requirements.
Ključne besede: lomna mehanika, visokociklično utrujanje, preizkušanje lomne žilavosti, nosilci kadi pralnega stroja, mejna obremenitev, ocena celovitosti konstrukcije, fracture mechanics, high cycle fatigue, fracture toughness testing, washing machine holders, washing machine drums, structure integrity assessment, limit load
Objavljeno: 10.07.2015; Ogledov: 547; Prenosov: 45
.pdf Celotno besedilo (517,04 KB)
Gradivo ima več datotek! Več...

2.
Experimental determination of fatigue parameters of high chromium steel under different loading and temperature conditions
Matej Drobne, Nenad Gubeljak, Srečko Glodež, 2014, izvirni znanstveni članek

Opis: Fatigue investigation of high chromium steel (HCS) at different loading ratios (R = 0, R = -1) and different temperatures (20 °C, 600 °C) is presented in this paper. Before fatigue testing, monotonic mechanical properties (ultimate compressive and ultimate tensile strength) are determined at different temperatures, using standardized testing procedures according to DIN 50125 standard. Moreover Charpy impact tests at different temperatures were done with specimens that comply with the standard ISO 14556. Fatigue testing is performed on a servo - hydraulic testing machine with consideration of different loading conditions as described above. On the basis of the experimental results the S - N curves are constructed from which typical fatigue parameters (the fatigue strength coefficient 0'f and the fatigue strength exponent b) are determined. After fatigue testing a comprehensive investigation of fracture surfaces is performed using the Scanning Electron Microscope (SEM). Experimental results presented in this paper will serve as a basis for further investigations related to fatigue behaviour of real working rolls in hot strip mills made of HCS.
Ključne besede: experiments, high chromium steel, high cycle fatigue, fracture mechanics
Objavljeno: 12.07.2017; Ogledov: 244; Prenosov: 62
.pdf Celotno besedilo (2,88 MB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.05 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici