| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
Pitting formation due to surface and subsurface initiated fatigue crack growth in contacting mechanical elements
Gorazd Fajdiga, Srečko Glodež, Janez Kramar, 2007, izvirni znanstveni članek

Opis: A computational model for simulation of surface and subsurface initiated fatigue crack growth due to contact loading is presented. The model is based on fracture mechanics theory where the required materials properties are obtained from common fatigue tests. For computational simulations an equivalent model of two contacting cylinders is used instead of simulating theactual contact of mechanical elements. The discretised model with the initial crack on or under the surface is then subjected to normal contact pressure, which takes into account the EHD-lubrication conditions, and tangential loading due to friction between contacting surfaces. The model considers also the moving contact of mechanical elements and for the surface initiated crack also the fluid trapped in the crack. The virtual crack extension method, implemented in the finite element method is then used for simulating the fatigue crack growth from the initial crack up to the formationof the surface pit. The numerical results correspond well with available experimental data. The described model can be used for simulation ofpitting phenomenon of contacting mechanical elements like gears, bearings, wheels, etc.
Ključne besede: fracture mechnaics, machine elements, gears, contact fatigue, pitting, subsurface crack initiation, computational analysis
Objavljeno: 31.05.2012; Ogledov: 1364; Prenosov: 74
URL Povezava na celotno besedilo

Effect of residual stresses on the fatigue crack propagation in welded joints
Nenad Gubeljak, Jožef Predan, Reinhard Pippan, Maks Oblak, 2005, izvirni znanstveni članek

Opis: The effect of residual stress on the fatigue crack growth was investigated forcyclic tension. Three-point bend specimens were used with through thicknessnotches at the center line of the welded joint. The experiments were performed for different load amplitudes and load ratios under conditions of small-scale yielding. The influence of the residual stresses on fatigue crack growth was estimated by experimentally observed fatigue crack growth rate and measurement of residual stresses at the surface of specimen. This paper describes an approach taken in two models to estimate the residual stress effect on fatigue crack propagation and to predict remaining service life of awelded structure.
Ključne besede: fracture mechnaics, fatigue crack, crack growth, residual stresses, fatigue crack growh rate, X-ray
Objavljeno: 01.06.2012; Ogledov: 1247; Prenosov: 61
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.03 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici