| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 1 / 1
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Comparative model analysis of two types of clamping elements in dynamic conditions
Petar Todorovic, Borut Buchmeister, Marko Djapan, Djordje Vukelić, Marko Milosevic, Branko Tadic, Milan Radenkovic, 2014, izvirni znanstveni članek

Opis: This paper studies the compliance of the fixture-workpiece system. Workpiece clamping case with two types of clamping elements is considered. The first type of clamping element is standard, with flat top, while the second one is specially designed, with round cutting insert. Analyzed was the case of workpiece clamping using small forces, whereby the deformations in the workpiece/clamping element interface are predominantly on the order of magnitude of roughness height. A comparative analysis of dynamic behaviour of both types of clamping elements is also presented. In comparison with its standard counterpart, the specially designed clamping element with round cutting insert has superior clamping performance regarding both tangential load capacity and compliance.
Ključne besede: clamping, clamping element design, product development, machining, cutting, compliance, fixture, roughness, analysis, dinamical behaviour
Objavljeno: 11.07.2017; Ogledov: 235; Prenosov: 49
.pdf Celotno besedilo (1,39 MB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.01 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici