Development of polymeric materials with rutin and polyrutin for healing of chronic leg ulcersTanja Pivec
, 2018, doktorska disertacija
Opis: In this work, the development of cellulose wound dressing materials with rutin (RU) and polyrutin (PR) for the healing of chronic leg ulcers is presented as a new approach of local treatment of this wound type. The flavonoid rutin is a known antioxidant substance of plant origin with wound healing promoting properties. Despite the proven beneficial properties of rutin, its potential application in wound healing is limited due to its low water solubility. This limitation can be overcome by polymerization of rutin into polyrutin. In this work an enzymatic polymerization of rutin in water without addition of organic solvents was performed to obtain a water-soluble polymer polyrutin. The chemical structure of rutin and polyrutin were investigated using UV-Vis spectroscopy, nuclear magnetic resonance spectroscopy, Fourier transform infrared spectroscopy, size-exclusion chromatography and potentiometric titrations. Biological activity related to a desired positive influence on chronic leg ulcers was investigated through the determination of the antioxidant activity, iron-chelation ability, cell viability, determination of cell proliferation and through use of the so called “scratch assay” to measure in vitro wound healing performance. Results indicate that rutin and polyrutin have a positive influence on the healing of chronic wounds. Rutin and polyrutin water dispersions at different pH and ionic strength were further characterised by means of dynamic light scattering in order to determine the size of particles and their pH dependent ζ-potential. The knowledge gained from these measurements aided the systematic interaction studies of rutin and polyrutin dispersions with cellulose-based surfaces via model and real wound healing systems. The model cellulose surfaces were thin films prepared by dissolution of trimethylsilyl cellulose in tetrahydrofuran, spin-coating of this solution on sensors of a quartz crystal microbalance (QCM-D) and subsequent regeneration of trimethylsilyl cellulose to cellulose with acid vapors. The influence of pH, salt concentration, and rutin/polyrutin concentration on the interaction with cellulose thin films was evaluated by means of a quartz crystal microbalance with dissipation. This knowledge was transferred to the application of the coatings on real wound healing systems i.e. cellulose non-wovens. The surface morphology was further characterised on model and real wound healing systems. The antioxidant activity and release kinetics were investigated for a real wound healing system, similar to the clinically used, cellulose based wound dressing materials. The main results showed that a higher solubility of polyrutin at low ionic strength contributes to the formation of continuous layers of polyrutin on cellulose surface, while the low solubility of rutin and reduced solubility of polyrutin at higher ionic strengths contribute to deposition of particles of rutin and polyrutin on the cellulose surface. The presence of particles on the surface of non-woven cellulose fibres led to a faster initial release of rutin and polyrutin. On the contrary, a continuous layer of the well soluble polyrutin contributes to a prolonged release. Namely, adsorption of the water soluble polyrutin at pH 2 without the addition of salt results in higher masses of attached polyrutin that release slower and over longer time periods. Since wound dressing materials for chronic leg ulcers often require a lower frequency of dressing change, the latter could provide an efficient therapeutic approach to their treatment.
Ključne besede: Chronic wounds, Wound dressings, Cellulose, Polymerization of flavonoids, Rutin, Polyrutin
Objavljeno: 11.06.2018; Ogledov: 592; Prenosov: 105
Celotno besedilo (7,34 MB)