| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 1 / 1
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Some factors affecting fatigue resistance of welds
Vladimir Gliha, Zijah Burzić, Tomaž Vuherer, 2010, objavljeni znanstveni prispevek na konferenci

Opis: The fatigue strength of polycrystalline metals is hardness and defect size dependent. The fatigue strength of welds depends on the size of grains and actual local mean stress, too. Local mean stress is influenced by the global R-ratio and static preloading. The welds in the as-welded condition are pre-stressed due to the existence of welding residual stresses. The sign and magnitude of residual stresses depend on the welding conditions. Changes of residual stresses, hardness and defect size are experimentally determined in the present work. Samples of studied metals are prepared by using either thermal cycle simulator or laboratory furnace and water quenching. The methods of microstructure preparation and type of load result in actual local R-ratio at the used weld toe models. Specimens are cyclic loaded in the similar way as steel at the weld toe. The bottom of the notch is either defect-free or defected by Vickers indentation. Final results show that coarser grain and higher local R-ratios lower the fatigue strength of welds.
Ključne besede: CrNiMo steels, weld, fatigue resistance, heat-affected zone, small weld defects
Objavljeno: 31.05.2012; Ogledov: 881; Prenosov: 10
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.03 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici