| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 5 / 5
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Use of AFM force spectroscopy for assessment of polymer response to conditions similar to the wound, during healing
Uroš Maver, Tina Maver, Andrej Žnidaršič, Zdenka Peršin, Miran Gaberšček, Karin Stana-Kleinschek, 2011, izvirni znanstveni članek

Opis: Force spectroscopy is a very promising technique for the evaluation of interactions within different environments. Knowledge about them is especially important during the design and preparation of those modern wound dressings in contact with a changing wound-environment over a prolonged time. Such exposure can cause a drastic decrease in the materialćs mechanical performance, and can lead to degradation, thus lowering the success of any healing process. Our study tries to establish a model system, which would enable us to assess the applicability of the mentioned technique for the evaluation of any interaction changes between polymer molecules and a chosen surface, after exposure to different environments. Our proposed experimental setup consists of two representative polymers, a model silicon surface, and two solutions of various pHs and ionic strengths, respectively. Within the chosen range of parameters, we are confident that we can prove the usefulness of force spectroscopy for further research into polymer suitability, for the development of novel wound dressings.
Ključne besede: force spectroscopy, AFM, wound dressings, polymer materials, model system
Objavljeno: 01.06.2012; Ogledov: 1081; Prenosov: 51
.pdf Celotno besedilo (316,48 KB)
Gradivo ima več datotek! Več...

2.
3.
Preparation and electrochemical characterization of aluminium liquid battery cells with two different electrolytes ($NaCl-BaCl_2-AlF_3-NaF$ and $LiF-AlF_3-BaF_2$)
Viktor Napast, Jože Moškon, Marko Homšak, Aljana Petek, Miran Gaberšček, 2015, izvirni znanstveni članek

Opis: The possibility of preparation of operating rechargeable liquid battery cells based on aluminium and its alloys is systematically checked. In all cases we started from aluminium as the negative electrode whereas as the positive electrode three different metals were tested: $Pb$, $Bi$, and $Sn$. Two types of electrolytes were selected: $Na_3AlF_6-AlF_3-BaCl_2-NaCl$ and $Li_3AlF_3-BaF_2$. We show that some of these combinations allowed efficient separation of individual liquid layers. The cells exhibited expected voltages, relatively high current densities and could be charged and discharged several times. The capacities were relatively low (120 mAh in the case of $Al-Pb$ system), mostly due to unoptimised cell construction. Improvements in various directions are possible, especially by hermetically sealing the cells thus preventing salt evaporation. Similarly, solubility of aluminium in alloys can be increased by optimising the composition of positive electrode.
Ključne besede: liquid batteries, aluminium, alloy, electrochemistry
Objavljeno: 24.08.2017; Ogledov: 319; Prenosov: 176
.pdf Celotno besedilo (316,77 KB)
Gradivo ima več datotek! Več...

4.
5.
Impedance measurements on the passive layers of stainless different heat treated steels
Mojca Slemnik, Valter Doleček, Miran Gaberšček, 2002, kratki znanstveni prispevek

Opis: The behavior of differently heat-treated X20Cr13 steels in 0.1 M H2SO4, was studied using the electrochemical impedance spectroscopy. Impedance spectra were recorded at constant passsive potentials of 0.2, 0.4 and 0.6 V vs. SCE, respectively. At low passive potential, 0.2 V vs. SCE, impedance spectra typical for an active - passive transition were observed. The assumption has been made, that they are the result of the adsorption process, caused by boundwater, which blocks the passive layer of steel and leads to corrosion rate reduction. The process is the most significant at the oil and the air-quenched, but less at the tempered steel. When more noble potentials are approached the impedance spectra become typical for passive metals and the value of resistance and capacitance differ from each other with respect to the heat treatment.
Ključne besede: korozija, nerjavna jekla, impedanca
Objavljeno: 10.07.2015; Ogledov: 723; Prenosov: 14
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.12 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici