| | SLO | ENG | Piškotki in zasebnost

Večja pisava | Manjša pisava

Iskanje po katalogu digitalne knjižnice Pomoč

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
2.
Modifying the brake drum geometry to avoid selfexcited vibrations and noise
Miha Pevec, Darko Vranešević, Grega Oder, Iztok Potrč, Matjaž Šraml, 2012, izvirni znanstveni članek

Opis: A squealing noise of 50 dB was measured on a vehicle homologation test at around 900 Hz on the existing brake drum design, mounted on the rear axle of the mid-sized passenger automobile. Therefore, analysis of eigenfrequencies of the original drum design was performed using the impact hammer test and numerical analysis. It was established that a critical mode shape 0/2 exists at around 900 Hz, exactly where the squeal noise was recorded at the brake road noise evaluation vehicle test. The analysis was carried out with the intention to eliminate the possibility of the squealing noise by increasing the critical mode above 900 Hz. The relation between different brake drum modifications parameters and the eigenfrequencies was determined and the best solution was obtained. The first eigenfrequency of the proposed drum design was increased by 58 Hz and the difference between the in-plane and out-of plane mode shape was sufficient. We can conclude that the modified drum design will not have squeal issues at 900 Hz as there are no eigenfrequencies of the brake drum in that range and therefore the problem of the loud brake is solved.
Ključne besede: zavorni disk, lastna frekvenca, metoda končnih elementov
Objavljeno: 10.07.2015; Ogledov: 487; Prenosov: 29
URL Povezava na celotno besedilo

Iskanje izvedeno v 0.06 sek.
Na vrh
Logotipi partnerjev Univerza v Mariboru Univerza v Ljubljani Univerza na Primorskem Univerza v Novi Gorici