| | SLO | ENG | Cookies and privacy

Bigger font | Smaller font

Search the digital library catalog Help

Query: search in
search in
search in
search in
* old and bologna study programme

Options:
  Reset


1 - 1 / 1
First pagePrevious page1Next pageLast page
1.
Factors influencing the yielding constraint by cracked welded components
Dražan Kozak, Jelena Vojvodič-Tuma, Nenad Gubeljak, Damir Semenski, 2005, original scientific article

Abstract: The effect of strength mismatch for welded joints performed with different geometries on the yielding constraint has been investigated in the context of single-edged fracture-toughness specimens subjected to bending SE(B) using the finite-element method. The crack was located in the centre of the weld. Two geometri cal parameters have been identified as being the most important: the crack-Iength ratio a/W and the sIenderness of the welded joint (W-a)/H. They were systematically varied as follows: a/W = 0.1; 0.2; 0.3; 0.4; 0.5 and W = 2H, 4H, 8H, 16H, 24H. Basic equations and plane-strain finite-element solutions for the overmatched SE(B) specimen with all configuration combinations are given. The results are in good agreement with those in literature. This paper aims to establish yield-Ioad solutions for the same weldment configurations, but with materials dissimilarity present within the weld. This situation is usually encountered during repair welding. For this purpose, a practical combination of filler materials, with the same portion of overmatched part with M = 1.19 and undermatched part with M = 0.86, has been selected. Plane-strain solutions for the heterogeneous weld with the cracklocated in the overmatched half were obtained. The influence of the yielding-constraint key parameters has al so been evaluated. Yield-Ioad results for the specimens performed with different weld widths have the greatest scattering for the a/W = 0.5. The transition from the overmatched to the undermatched solution with increasing H is evident. On the other hand, the behaviour of the specimen with a shallow crack is dictated by the overmatch region ahead of the crack tip and depends very little on the weld slenderness. An approximated 3-D area of the yield-Ioad solutions depending ona/W and (W-a)lH has been proposed. Furthermore, the stress triaxility parameter h has been calculated using 2-D and 3-D finite-element analysis, and given as a field in the spec imen to get an insight into yielding-constraint regions. It was found that the 3-D yield-Ioad solutions are very close to the plane-strain solutions. Also, the effect of a/W on the yielding constraint is more significant than the effect of Mand (W-a)/H.
Keywords: welded structures, welded joints, fracture mechanics, cracks, SE(B) specimens, yielding load, yielding constraint parameters
Published in DKUM: 06.04.2017; Views: 1488; Downloads: 120
.pdf Full text (793,79 KB)
This document has many files! More...

Search done in 0.03 sec.
Back to top
Logos of partners University of Maribor University of Ljubljana University of Primorska University of Nova Gorica