1.
Optimization of the distribution network operation by integration of distributed energy resources and participation of active elementsNevena Srećković, 2020, doctoral dissertation
Abstract: Distribution Networks (DNs) are evolving from a once passive to an active part of the electricity network. This evolution is driven by the current political and environmental decisions, Directives and Incentives, as well as the technological development, observed in the everincreasing integration of renewable energy resources, advanced network control and measurement devices, the upcoming energy exibility market, etc. This Doctoral Thesis deals with the problem of optimization of the technical aspects of a DN operation, enabled by the proliferated integration of the photovoltaic systems (PV) and other active devices. The main objective of the Thesis is the optimization of a DN operation in terms of minimization of electrical energy losses while ensuring the proper voltage profiles and preventing thermal overloadingof lines. Therefore, three Differential Evolution-based optimization procedures were developed and tested on real medium and low voltage DNs. The first methodology determines the optimal rooftop surfaces for the installation of PV systems, yielding minimum annual energy losses. It is based on the simultaneous consideration of high-resolution spatio-temporal solar and PV potential data, as well as long-term measured profiles of consumption and generation of electrical energy within the network of a given configuration. The second algorithm minimizes network losses in a time-discrete operation point, by determining the optimal operation of the following active elements: PV systems capable of cooperation in reactive power provision, On-Load Tap Changer equipped transformer substations and remotely controlled switches for network reconfiguration. The final algorithm was developed by a proper consolidation of the first two approaches, yielding the synergistic effects expressed as the increase of loss reduction and network exibility. The results of the performed case studies show that the locations of the highest suitability for PV installation with respect to the solar energy availability, are not necessarily the best choice from the network operation standpoint. Therefore, both standpoints should be considered simultaneously when choosing the rooftop surfaces for PV installation. Furthermore, by determining optimal hourly operation of the considered active elements, not only the additional reduction of annual network losses was achieved, but also increased accommodation of the PV systems that doesn't violate operation constraints.
Keywords: distribution network, optimization of operation, active network elements, PV system placement, minimization of losses
Published in DKUM: 11.06.2020; Views: 1867; Downloads: 423
Full text (44,58 MB)